This is the simulation control class of Visual Calculator for SansGUI.
Use the Default object from this class to control execution/simulation parameters.
This class does not contain any attributes defined by Visual Calculator; all attributes are inherited from class SimControl.Cycle in the SansGUI Environment. Please consult the SansGUI Manuals for more details. Two of the attributes require more attention:
Ending Cycle Number (iEndCycle): is, normally, set to one for a single cycle execution. It can be set to a higher value for multiple cycle runs when the model contains loops (Example 3) or uses the Base.SineGen component (Example 4).
Part Evaluation Order (iOrder): should be set appropriately according to the orientation of the model. If it is not properly set, the calculated results may not be correct.
Go to Introduction
Visual Calculator for SansGUI Version 1.1
Copyright © 2001-2003 ProtoDesign, Inc. All rights reserved.